- Meets current standards, including more stringent Texas DOT requirements.
- Multi-function electronic controller tracks time, speed, and total revolutions.
- Easier, safer, and less expensive to operate.
- Lexan doors and safety interlocks insure no exposed moving parts.
The increasingly popular Micro-Deval test measures abrasion resistance and durability of mineral aggregates. An aggregate sample is placed in a sealed stainless steel jar with an abrasive charge of up to 5,000g of 9.5mm diameter stainless steel balls and water, then rotated at 100rpm for two hours. Aggregate quality is determined by percentage loss in gradation results at completion. Smaller equipment size, lower sample quantities and a simpler procedure make the method easier and less costly to perform than traditional methods.
The MD-2000 meets current ASTM, AASHTO, and Canadian test methods, as well as more stringent Texas DOT requirements. This contemporary version of the Micro-Deval test should not be confused with older versions originating in Europe which use different equipment and test protocol. Gilson’s MD-2000 Micro-Deval Apparatus is a second generation, state-of-the-art machine. A sophisticated electronic controller with optical sensing system accurately tracks test time, total revolutions and rpm of jars. Test duration may be controlled by either elapsed time or total revolutions. Jars stop within a fraction of one revolution at test termination. Jar revolution and speed data may also be used as a verification of machine performance.
The jars revolve behind closed Lexan™ doors with safety interlocks. No moving parts are exposed during operation. Other manufacturers use separate timers to control test duration, which does not permit tracking of jar revolutions or speed and allows variations up to ±6% of the optimum number of revolutions. In addition, other machines rotate the jars on unguarded open rollers, creating a hazardous situation.
The Micro-Deval machine is a two-tier unit with sturdy steel frame. Each tier carries one stainless steel 5L jar, 194mm ID, 170mm internal height with locking cover. Power to the rubber-covered rollers is supplied by a 3/4hp, electric motor through a gear transmission and chain drive. The unit is supplied with two jars and two 5,500g abrasive charges. A magnet is included to assist in removing the abrasive charge after the test is complete. For additional sample preparation capacity and greatly reduced testing times, order additional Jars HMA-920 and Abrasive Charge HMA-922. Overall Dimensions: 20.5x13.5x38in (521x343x965mm). Electrical: operates on 115V/60Hz. Add "F" to model number for operation on 230V/50Hz power supply. Optional MD-2000C model is equipped with thermally protected motor to meet stricter requirements in some areas. Check your local code before ordering.
|
